What Size Socket To Replace Water Heater Element

Drive x 1 1 2 in.

What size socket to replace water heater element. Replacing water heater element on atwood the heating element on your atwood model gc10a 4e water heater our part at94022 should be on the backside of the unit towards the. There is an actual tool available that is used to remove them. If you don t already have a honkin big breaker bar get one of those too.

Then either rent or buy a impact wrench air or electric. Oneness 369 water heater element hex socket with anode rod hex socket wrench removal tool tube spanner 1 1 16 x 1 1 2 x 6 length 4 8 out of 5 stars 1 219 10 95 10. I think you can find them in big box stores where they sell water heater elements.

What size socket wrench is the element for electric water heaters. Confidently loosen and remove stubborn corroded heating elements with the tekton 1 2 in. Basically a 5 piece of pipe with a 1 1 2 hex socket formed in one end and a steel rod that inserts at the opposite end to turn it.

I have one in my plumbing kit. Remove a flange type heating element by removing the four screws holding the element in place. This is no job for a sissy 3 4 drive ratchet wrench.

Looks like an oversized spark plug wrench. Go measure the size of the hex head on a new element for your heater i think they are 1 1 4 but not sure. Right now while you re thinking about it buy yourself the nice 6 point 1 1 16 inch impact socket you ll need to extract the anode rod from your water heater.

Turn the screw in heating element counter clockwise leftie loosie to remove it. We use a large 1 5 diameter socket wrench to get these elements out as it s easier than bumping around with a wrench. With mounting screws and gasket removed extract the heating element from the water heater.