Wire Weave Lamp

Coil the weaving wire onto the inner curve wire for about 5 8.
Wire weave lamp. Remove the plug from its case and feed the wire through the hole in the base of the plug. Repeat this step for the other wire end. Squeeze the prongs together until you feel the wire being pierced by the prongs.
Make a loop in the left wire and hold the end of the wire on the back of the right side. 18 2 stranded lamp wire black spt 2 lamp wire is intended for use in small spt 2 lamp wire is intended for use in small household appliances including clocks lamps radios and fans that are not subjected to hard usage. 4 6 out of 5 stars 636.
Nickel plated mesh wire weaved with fairy lights combined to create these alluring and highly original lamps. Cut the frame wire 1 8 from the top of the coil and file it smooth. Available in small medium and large they are stylish by day and even more so by night.
Tie the two ends of the black wire that hangs below each light socket cap together in an underwriter s knot. The meter should indicate continuity on one prong only. Make a clean cut at the end of your lamp s base wire using needlenose pliers.
Set a multitester to rx1 and clip one probe to one wire end. Unplug the lamp and remove the socket. 5 out of 5 stars 92 92 reviews 195 00.
5 out of 5 stars 156 156 reviews 6 99. Place the other probe against one plug prong and then the other. Favorite add to.